BME280 is temperature, humidity and air pressure sensor based on Bosch-Sensortec chip. 1wire sockets are intended to use with DS18B20 sensors without plugs.
Multiplication 1Wire input (Screw terminal) in lankontroler which allows connection of up to 4 temperature sensors DS18B20
Temperature and humidity sensor with a cable, approx. 25 cm long, terminated with an RJ12 connector (I2C bus). It fits our Lan Controller V3.5, Arduino, Raspberry and many other projects.
Temperature and humidity sensor with a cable, 300 cm long, terminated with an RJ12 connector (I2C bus). It fits our Lan Controller V3.5, Arduino, Raspberry and many other projects.
This sensor builds on the photoacoustic sensing principle. Sensor board is equipped with an I2C interface.
Digital temperature sensor with cable and RJ11 connector as standard Lan Controller. The sensor in the digital 1-Wire bus standard, compatible with DS18B20 sensors. Each sensor is programmed with a serial ID number, which allows for reading multiple sensors on one bus. The aluminum substrate enables very fast heat transfer to the sensor.