Premiere: Enhanced Enclosure, Advanced Hardware - Introducing the new LAN Controller LK4.0. The new LK4 integrates our previous IoT experiences into one universal device. It represents a seamless continuation of the previous LAN Controller series. Note: Some functions presented in the interface may not work yet.The software upgrade will be available at...
The board is designed as an overlay on Lan Controller in the second version and is located in the original housing. It is equipped with 4 high-power MOSFETs that can be used to power devices with power consumption 1-3a.
BME280 is temperature, humidity and air pressure sensor based on Bosch-Sensortec chip. 1wire sockets are intended to use with DS18B20 sensors without plugs.
The tHAT2 overlay offers an additional 4 relay outputs in open collector standard, which are controlled from the PWM outputs. The board also has a RS485 converter to support Modbus. OUT1-4 relay outputs and supply voltage, analog inputs INPA1 and INPA2 as well as voltage 3.3V to supply sensors are also led out.
GSM Controller v4.2 is a small device with many functions. It can send sensor readings or execute on/off commands via SMS, call, MQTT (via GPRS data transmission to server or application). It also has the function of automating actions and sending notifications as a result of events or reaching a value.
AC-METER is a measurement transformer ZMPT101B with amplifier.Sensor board is prepared for 1 phase AC voltage measurement.
Dusk sensor are circuit of specially selected photoresist and resistor.
Managed power distribution unit in Rack 19 inch cabinet standard. Equipped with 7 independently managed sockets connected to grid (230V) voltage.PDU can be managed via the built-in web server or the SNMP or MQTT protocol via the physical 10/100Mb Ethernet interface.
The basic tB3 expansion board contains:- RJ12 input from Lan Controller: I2C/1wire- I2C splitter - 1xRJ12, 1xI2C micro 1.25 mm, OLED 0.96 inch socket (2.54 mm pitch)- 1-Wire splitter - 2x RJ12.The board has 4x RJ12 slot and a micro JST 1.25mm connector for the I2C bus, e.g. for connecting the BME280 sensor.